Bloat Guard
FULL PRESCRIBING INFORMATION: CONTENTS*
- Active Ingredient
- CAUTION:
- Directions for Use as Top Dress on Feed
- Warning:
- STORAGE AND HANDLING
- Principal Display Panel
FULL PRESCRIBING INFORMATION
Indications for Use:
For prevention of legume (alfalfa, clover) and wheat pasture bloat in cattle
Active Ingredient
Poloxalene . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 53%
(Each 2/3 oz by weight of top dressing contains 10 g of poloxalene)
Verxite® #4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47%
CAUTION:
Certain components of animal feeds, including medicated premixes, possess properties that may be a potential health hazard or a source of personal discomfort to certain individuals who are exposed to them. Human exposure should, therefore, be minimized by observing the general industry standards for occupational health and safety.
Precautions such as the following should be considered: dust masks or respirators and protective clothing should be worn; dust arresting equipment and adequate ventilation should be utilized; personal hygiene should be observed; wash before eating or leaving a work site; be alert for signs of allergic reactions—seek prompt medical treatment if such reactions are suspected.
Directions for Use as Top Dress on Feed
The dose for Bloat Guard is proportional to the body weight and also depends upon the severity of the bloat-producing conditions. The dose of 1 g of poloxalene per 100 lb of body weight is recommended for cattle under moderate bloat-producing conditions. For cattle under severe bloat producing conditions, the dose should be doubled (2 g of poloxalene per 100 lb body weight).
Use the enclosed measure which is equal to 1/4 of a standard measuring cup and holds approximately 2/3 oz of Bloat Guard by weight. Each 2/3 oz by weight contains 10 g of poloxalene (the active drug ingredient).
Daily Dosage
Animal Weight ( lb ) |
Number of Measures |
Dose (grams) |
500 |
½ to 1 |
5 to 10 |
1000 |
1 to 2 |
10 to 20 |
1500 |
1 ½ to 3 |
15 to 30 |
2000 |
2 to 4 |
20 to 40 |
Bloat Guard is to be consumed daily. Bloat Guard should be sprinkled on individual rations of ground feed, starting 2 or 3 days before animals are exposed to bloat-producing conditions.
Repeat the feeding of Bloat Guard when animals are exposed to bloat-producing conditions more than 12 hours from the last feeding of Bloat Guard, but do not exceed the higher dosage levels in any 24-hour period.
If your animals do not accept Bloat Guard readily, stir the recommended amount into their feed. After animals become accustomed to the change in diet, sprinkle Bloat Guard on top of feed.
Caution: It is essential that each animal consumes the total recommended dose of Bloat Guard daily for adequate protection.
Warning:
The normal life of this product is at least 24 months. However, when the product is subjected to extreme temperatures (38°C/100°F) for long periods of time (6 months), spontaneous combustion may occur. The product is not combustible unless it develops a strong, irritating odor; if this occurs, flush with water and discard immediately.
NOT FOR HUMAN USE
STORAGE AND HANDLING
Store At Or Below 25oC (77oF), Excursions Permitted Up To 40oC (104oF
Follow Directions on Back Panel
Bloat Guard® is a Phibro Animal Health Corporation registered trademark for Poloxalene
Phibro Animal Health Corporation, Teaneck, NJ 07666.
Verxite® is a registered trademark of W.R. Grace & Company.
NADA #32-704, Approved by FDA
6080000
101-9030-07
Principal Display Panel
[Bloat Guard Label image
Bloat Guardpoloxalene POWDER
|