ProCure Hand Sanitizing
Pro Cure Hand Sanitizing Wipes
FULL PRESCRIBING INFORMATION: CONTENTS*
- ACTIVE INGREDIENT
- ProCure Hand Sanitizing Uses
- WARNINGS
- Directions
- Other Information
- Inactive Ingredients
- Labeling
FULL PRESCRIBING INFORMATION
ACTIVE INGREDIENT
ALCOHOL 65.9% BY VOLUME
PURPOSE
Antiseptic
Uses
- Antiseptic
- For handwashing to decrease bacteria on the skin; after assisting ill persons; and before contact with a person under medical care treatment
- Apply topically to the skin to hep prevent cross-contamination
- Recommended for repeated use.
- Dries in seconds
WARNINGS
Flammable, keep away from fire and flame
For extermal use only.
Do not use
in or contact the eyes
Discontinue use
If irritation and redness develop. If condition persists for more than 72 hours, consult a physician.
Keep this out of reach of children
unless under adult supervision.
If swallowed, get medical hep or contact a Poison Control Center immediately.
Directions
To start feed: REmove cover and discard seal from container. From center of toweled roll, pull up wipe corner; tear off first wipe for use. Twist next wipe into a point and thread through hole in the container cover. Pull thrugh about one inch. Replace cover. Pull out wipes as needed and sanp off at a 90 degree angle. Keep cap closed to prevent evaporation.
Wipe hands, fingers, interdigital areas and wrists thoroughly with towelette. Be sure to utilize the entire wipe surface. Allow to dry.
If hands are visibly soiled or contaminated, use first wipe to clean hands, then discard wipe. Sanitize with a second wipe.
Discard after single use.
Other Information
Lot Number and Expiration Date can be found on container
Inactive Ingredients
Water, Propylene glycol, Glycerin, Carbomer, Aminomethylpropanol, Aloe barbadensis leaf juice, Tocopheryl acetate.
Labeling
ProCure Hand SanitizingALCOHOL SWAB
|